![]() There is likely a rubber gasket you’ll see first. Now, unhook each water inlet hose and look for the filter at the top of it. It wouldn’t hurt to check them though while you are behind the machine. The filters on the inlet hoses can also catch debris, although they would present more problems for water flowing into your tub than draining. Hoses, including the drain hose and the water inlet hoses, should be replaced every five years. Another method is to blow through the open end of the hose as hard as you can to blow out the clog. Now, you can use the snake to unclog the drain hose. If water doesn’t flow into the bucket, then you have a clog in the drain hose. If it doesn’t, you may need to call a plumber. Wait about an hour and put the drain pipe back into the drain. If that is unsuccessful, put some clog chemical into the pipe with a little water. Take the snake and push it into the drainpipe to see if it will unclog. You may have to empty the bucket a couple of times because the water will continue to flow from the washer tub. Then, you know you likely have a clog in the drainpipe itself. If it doesn’t have a clog, water will flow from it into the bucket. Put the bucket on the floor and put the drain hose in it. Also, make sure the hose is put into the drain correctly it should only be 4.5 inches down the drain. Be sure to look for those things as you are working with your hose. Sometimes, drain hoses can get twisted or pinched. Pull the machine a little bit away from the wall. To do that, you will need a bucket, a chemical to break up the clog, and possibly a tool called a “snake.” A snake is a steel cable you put through the drain to unclog it. If this happens, you will need to unclog your drain. A clog in the drain typically has an additional symptom of the water leaking from the drain where the hose goes in onto the floor. Sometimes the drain itself can get clogged preventing water from flowing from the washer. The first thing to do is turn off your machine. The first thing you should do is look for a clog. Sometimes, the simplest solution is the correct one. You may not have to call a repair technician or buy a replacement part for your Speed Queen washer. It typically means you have a drain pump issue, a clog, or something stuck in the machine causing water to not drain properly. This will come up as an error toward the end of a wash or rinse cycle. The Speed Queen washer code LD stands for “long drain.” It means it is taking your washer too long to drain out the water after a cycle. Is this going to be something to mess up your entire day? No, probably not. The day is busy and you have to get all the laundry done. You think everything is working fine with your Speed Queen washer.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |